Unibilt Conveyor Components

FOB: Midwest Warehouse

Webb Unibilt® Conveyor Components are high quality components for any Webb Unibilt Conveyor!

Extended H Attachment V16984
Extended H Attachment V16984 is used to extend the carrier or load away from the track for additional clearance when traveling vertically.

Spinner Attachment V21517

• Used where continuous rotation of product is necessary through a wash or paint finishing operation
• Ball bearing roller revolves against a flat bearing strip by the forward motion of the conveyors

Extended Rigid H Attachment

• Used primarily on conveyors with vertical travel
• Attachment holds the carrier or load away from the track when traveling vertically
• 8" inch offset is standard

NOTE: Special offsets can be fabricated to order.

90° Star Wheel Indexing Swivel Hook Assembly V8345

• 90° indexing swivel allows for carrier rotation in 90° degree increments with the use of a camming device
• Made of malleable iron
• Shipped loose in two pieces
• V16164 swivel and V6513 shank

Wheel Chain Attachments V16949

• Attachments are a heat treated high strength, drop forged steel that can be installed in the chain on nominal 8" inch centers as required
• Use of this unit increases individual load capacity to 250 lbs. per unit

Wheel Chain Attachments V16971

• Attachments have the same construction as V16949
• Also can have a 1/2" inch diameter shaft or bolt inserted in the frame
• Capacity: 250 lbs.

4 Wheel Chain Attachment V21064

• Attachments have the same construction as V16949 and V16971 but include a guide roller for stability when used in inverted applications
• Capacity: 250 lbs.

Inverted Chain Attachment Assembly with Load Bar V21067

• Assembly is used with a C hook application
• Attachments have the same construction as V21064

Lubrication: Brush Type Chain Oiler V20053 and V20058

• • Unibilt chain lubricators
• Provides oil lubrication to the guide and load wheel bearings, and to each pivot in the chain assembly
• Proper amount of lubricant can be regulated with an adjustable needle valve
• To assure adequate lubrication at each point without over-oiling and dripping
• Proper lubrication is necessary to maintain the low friction of the conveyor system, decrease system wear and maintenance, and prolong the life of the system
• Includes a one quart transparent oil reservoir, a visual sight guage for oil feed and a manual on/off valve
• Chain lubricator V20058 is the same as V20053 except that V20058 is equipped with an electric On/Off valve for remote control operation
• Can be adjusted to operate automatically only when the conveyor is running
• Both lubricators are shipped without a section of track
• Slot is to be cut in the field

NOTE: Not recommended for use in paint finishing systems.

Automatic Chain Lubricator V21516WS
The Unibilt Conveyor Chain Lubricator provides fully automatic oil lubrication at any desired interval.

• Nine (9) lubricating nozzles are individually are adjusted
• Provides positive and accurate metering to the load wheel
• Guide wheel bearings to each pivot point in the chain assembly
• Positive displacement type of actuator
• Guarantees the proper amount of lubricant at each point
• Eliminates over-oiling and dripping

The V21516WS automatic chain lubricator should always be used on systems with a high degree of contamination such as finishing systems with washers and ovens.

The lubricator is shipped complete with a 2' foot long section of track, eliminating track cutting or special mounting in the field.

NOTE: Not to be used with 4 wheel chain attachments.